This isn't your grandpa's muzzleloading method. Federal has designed a safer, much easier and even more dependable solution to shoot a muzzleloader.

Heavier than stock recoil springs make the two my G20s Much more liable to stoppages with hotter,  heavier ammo.   Odd, but perfectly documented on the web in case you lookup.

What I discovered was a really nice medium burn up level powder It's very good. Months later, all my preferred powders were being on The shop shelf, and I nonetheless purchased far more CFE-P

I loaded CFE at cost weights which were "from the books" to determine how it responded to surplus tension in an effort to make Key electric power Consider the .38 Tremendous and 9mm. I when compared it specifically with AC.

I’ve loaded afew a thousand of those and possess place them thru numerous instruments from p80s to caniks and run effortlessly.

I centered on velocity functionality and report the velocities from my pistols for the maximum printed weight. Starting off with the maximum load is not the recommended technique for testing, and clever folks will do the job their loads up slowly from the starting up load looking ahead to strain signs. I also loaded Several other powders that list significant velocities, like AutoComp, HS-six and Longshot to check relative overall performance.

We did not locate this powder to become as precise as its sister powder, WInchester Autocomp.  That is by using a CZ P10c 4" barrel with normal sights @  5 yards. 

Indeed it really works properly but not for surpressor use. As well gradual and doesnt melt away full sufficient. Sand blasting effect.

Again to old site Close If there is something within your cart, it will not be brought in excess of on the outdated internet site.

jre1954 mentioned: I acquired my two lbs of CFE pistol from a bullet casting/reloading click here store traveling to a city about one hour in addition to a 50 % absent. There is only IMR4227 and H110 on the shelves locally. The shop reloads with IDPA shooters being their most effective prospects.

This process was utilised principally to evaluate the relative condition on the CFE primers when compared with the AC primers.

CFE appears very much like AC, with similar densities and charge weights to achieve related velocities. Even so, it truly is unwise to suppose that CFE will perform securely for this activity with no mindful testing.

In .forty/10mm I've some 200gr nosler and 230gr bullets from xtreme As well as 140gr barnes xtac and 165gr fmj. Must go through much more to understand how a heaver grain bullets react to slower burning powder.

Over the reset failure. Are you currently using a stock excess weight get more info striker and set off spring? I believe the LW LS kit comes along with a light striker spring.